Unplug the unit. After a few minutes, plug the unit back in, turn the switches back on and give it one hour and recheck the water temperature If this does not correct the issue, please call our Customer Service Center.
Why is my water jug dispenser not working?
Very often if your water cooler is not working, the problem can be traced to the power supply So as a first step, check that it is properly plugged in at the wall and the mains power is turned on. If it is switched on but not dispensing water, the next step is to check your water supply.
Why is my Primo water dispenser blinking?
A flashing red function light alerts you when your bottle is empty Replace the bottle as soon as possible. CAUTION: Do not dispense hot, cool or cold water if the red light is flashing as you could empty the tanks and cause the dispenser to overheat. 1.
Why did my Primo water dispenser stop working?
Unplug the unit. After a few minutes, plug the unit back in, turn the switches back on and give it one hour and recheck the water temperature If this does not correct the issue, please call our Customer Service Center.
What are the 3 switches on back of Primo water dispenser?
CONVENIENCE SWITCHES – On/off switches for heating, cooling, nightlight and self-sanitization are located on the back of the dispenser. SELF-SANITIZATION LIGHT – Flashes green when sanitizing. COOLING LIGHT – Flashes blue when water is cooling. Light turns off when water is fully chilled.
How do you clean a Primo water dispenser probe?
Pour the bleach (2 tbsp.) or vinegar (2 cups) and hot tap water (2 Gallons) into the empty bottle. Apply the cleaning bottle to the dispenser. Plug the power cord back into the wall outlet and turn the dispenser back on. Allow the cleaning solution to fill the reservoirs.
How long do water dispensers last?
The Average Lifespan of Water Dispensers: The average lifespan of a water dispenser is between 3 to 5 years The original installation time is typically 5-7 years for residential models. Nowadays, though, some are made with better materials and will last even longer, up to 10 years.
Why is my liquid cooler not working?
There are a number of reasons why your water cooler might not be working as it should. For example, there could be a problem with the power source Or, there could be an issue with the compressor or refrigerator. There might even be a problem with a dirty filter.
Does Primo water dispenser have warranty?
Primo Water Corporation, (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall.
How do you set up a primo water dispenser?
Slide the bottle into the Primo Water Dispenser cabinet. Plug the water dispenser into a ground fault circuit interrupting outlet (GFCI). The water will begin to pump water into the hot and cold reservoirs. Turn on the desired functions in the back of the dispenser by flipping the switch on/off.
How long does a primo water dispenser last?
Primo water dispensers should last as long as the bottles are kept and serviced properly. However, the average lifespan of the primo water dispenser is not more than 6-12 months.
Can I leave water dispenser on overnight?
While each unit is designed to be left switched on 24/7 if you want them to be, it’s not energy-efficient to do so. To help you save money, you should switch the dispenser off at night to save electricity.
Can you use any 5 gallon water jug with Primo water dispenser?
A: All Primo water dispensers are designed to accept most standard 3 – 5 gallon plastic water bottles.
How do you clean the bottom load of a water dispenser?
- Turn off the hot water. Ensure that the hot water feature is turned off
- Add your cleaning solution to the reservoirs
- Rinse the unit
- Clean the interior and exterior of the cooler
- Replace your water bottle.
How do I reset my water cooler?
Option 3 – Try “resetting” your cooler by removing several cups of water from both the hot and cold taps and switch off the machine Unplug it from the wall and leave for 24 hours before switching it on again. Give the water temperature about 5 to 6 hours to adjust before dispensing to see if it worked.
Does Primo water dispenser have a filter?
Yes. Primo’s filtration process features activated carbon filtration and a reverse osmosis membrane to eliminate chlorine.
Where is the energy saving switch on Primo water dispenser?
Go to www.PrimoWater.com to find Primo Water at a store near you. Energy Saver Switches – Located on back of dispenser Switch red control to off to stop heating. Switch green control to off to stop cooling.
How much electricity does a primo water dispenser use?
1-1 of 1 Answer Our dispensers are rated 500 W (420 hot/80 cold). They are rated for 6 Amps. Daily average consumption (24 hour period) is less than 0.87 kWh/day when at idle. Power consumption will vary based on the consumer.
How do you clean a Primo water dispenser tray?
Remove drip tray assembly by pulling it forward. Remove cover. Place tray and cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water Perform: Every 3 months or whenever an off-taste occurs.
How do you clean a water dispenser with vinegar?
A vinegar cleaning solution is a natural and safe way to disinfect a water cooler. Mix a vinegar solution from 1 cup of distilled white vinegar and 3 cups of hot water (or any 1:3 ratio) and fill the cooler reservoir. Use a gentle scrub brush with a long handle to scrub the inside of the reservoir.
Can a water dispenser be repaired?
Water dispensers require maintenance and repair services Like other domestic appliances, your water dispenser is exposed to faults. Repair and maintenance technicians can fix issues such as: – Leaking water dispenser.
Can a water dispenser overheat?
Over 12,000 Nestlé Waters AccuPure floor standing filtration dispensers have been recalled because the dispensers can overheat and smoke, posing fire and burn hazards.
Why is my water filter not working?
Check that the threaded area where the filter will connect to the refrigerator has nothing blocking the small holes where the water will flow through Sometimes part of the wrapping on the new filter itself could possibly block the water flow. If something is blocking flow, this will cause low flow.
Is Primo good water?
Primo water uses membrane filtration technology which allows water to flow through the filter while leaving behind salt, chemicals, minerals and other impurities. The resulting water is highly purified, great-tasting healthier drinking water free of potentially harmful impurities.
Does a water dispenser need to be cleaned?
The U.S. Department of Energy recommends cleaning the cooler with every change of the bottle, or every six weeks, whichever arrives first Keeping the water clean is the most important part of maintaining your cooler. Fortunately, washing your dispenser requires only some time, water, and either bleach or vinegar.
What brand of water dispenser is the best?
- BEST OVERALL: Avalon Bottom-Loading Water Cooler
- Avalon Top-Loaded Cooler
- Brio Limited Edition Top-Loaded Cooler
- BEST BUDGET: Igloo Water Cooler
- BEST PREMIUM: Avalon Self Cleaning Dispenser
- Avalon Countertop Dispenser
- Brio Self-Cleaning Dispenser.
How do I know if my liquid cooler is broken?
The only way to accurately determine if your Liquid Cooling Pump is functioning, is by checking the Pump RPM This will only be possible if the pump cable is connected directly to a fan header on the motherboard.
How do you fix an airlock in a water cooler?
Airlock – This is a very simple problem that occasionally occurs with coolers that have just been installed or serviced. The cooler simply needs to be reset. This can be done by holding down/pressing both taps at the same time for a couple of minutes to allow the air to escape.