CHANGING BOTTLES A flashing red function light alerts you when your bottle is empty Replace the bottle as soon as possible.
Why is my primo water dispenser blinking red?
CHANGING BOTTLES A flashing red function light alerts you when your bottle is empty Replace the bottle as soon as possible.
How do you reset a Primo water dispenser?
Turn all switches to the off position. Unplug the unit. After a few minutes, plug the unit back in, turn the switches back on and give it one hour and recheck the water temperature.
How do you reset a water dispenser?
Option 3 – Try “resetting” your cooler by removing several cups of water from both the hot and cold taps and switch off the machine Unplug it from the wall and leave for 24 hours before switching it on again. Give the water temperature about 5 to 6 hours to adjust before dispensing to see if it worked.
What are the 3 switches on back of Primo water dispenser?
CONVENIENCE SWITCHES – On/off switches for heating, cooling, nightlight and self-sanitization are located on the back of the dispenser. self-sanitization light – Flashes green when sanitizing. COOLING LIGHT – Flashes blue when water is cooling. Light turns off when water is fully chilled.
How long does a primo water cooler last?
Primo water dispensers should last as long as the bottles are kept and serviced properly. However, the average lifespan of the primo water dispenser is not more than 6-12 months.
What causes water dispenser to stop working?
Clogged water filter Water filters should be replaced every six months on average. If you can’t remember replacing your water filter, it’s probably time to change it. These filters can get clogged over time causing the water flow to be disrupted and thus, preventing the water dispenser from functioning properly.
What causes water cooler to stop working?
Water cooler troubleshooting Very often if your water cooler is not working, the problem can be traced to the power supply So as a first step, check that it is properly plugged in at the wall and the mains power is turned on. If it is switched on but not dispensing water, the next step is to check your water supply.
Who makes Primo water coolers?
Primo Water Corporation (formerly Cott Corporation) is an american-canadian water company offering multi-gallon bottled water, water dispensers, self-service refill water machines, and water filtration appliances.
Why is my cooler pump not pumping water?
Your problem may be a lack of water, rather than a broken pump. Check to see that the pump is getting power. Some pumps plug directly into a standard electrical outlet, and some are wired inside of a box in the cooler. If the pump is not getting power, check the circuit breaker or the ground fault circuit interrupter.
Can I leave water dispenser on overnight?
While each unit is designed to be left switched on 24/7 if you want them to be, it’s not energy-efficient to do so. To help you save money, you should switch the dispenser off at night to save electricity.
How do you fix an airlock in a water cooler?
Airlock – This is a very simple problem that occasionally occurs with coolers that have just been installed or serviced. The cooler simply needs to be reset. This can be done by holding down/pressing both taps at the same time for a couple of minutes to allow the air to escape.
How do I get my Primo water dispenser to work?
Slide the bottle into the Primo Water Dispenser cabinet. Plug the water dispenser into a ground fault circuit interrupting outlet (GFCI) The water will begin to pump water into the hot and cold reservoirs. Turn on the desired functions in the back of the dispenser by flipping the switch on/off.
Where is the self cleaning button on a Primo water dispenser?
Visit www.PrimoWater.com to find Primo Water at a store near you. green control to OFF to stop cooling. Self-Cleaning Switch – Located on back left Press IN, hold for 3 seconds and release to activate the cleaning cycle.
How often should you clean your Primo water dispenser?
In order to ensure that the water you load into your Primo Top or Bottom Loading Water Dispenser retains its clean, fresh, and delicious taste, we recommend that you clean your Water Dispenser once every three months (unless, of course, you have opted for our Deluxe Bottom-Loading Water Dispenser with Self-Sanitization.
How much does it cost to run a Primo water dispenser?
It will shock you as it consumes a lot of electricity. Answer: If I calculate correctly, then at $2.00 per day, what you are saying is that your electricity consumption for using the Primo water dispenser costs approximately $60.00 per month.
How long does water stay good in a 5 gallon jug?
When people ask how long a five-gallon water jug lasts, some are wondering about shelf-life and others are wondering how long it will last in their home or office before they need to buy more. If it is shelf-life you are concerned about, you have a good six months before you need to replace your water jug.
Can you use any 5 gallon water jug with Primo water dispenser?
A: All Primo water dispensers are designed to accept most standard 3 – 5 gallon plastic water bottles.
How do I reset my whirlpool water dispenser?
After changing the water filter, reset the status. Press and hold the “WATER FILTER” button for 3 seconds When the system is reset, the water filter icon will return to its BLUE color and the words “Replace Filter” will disappear from the display.
Is Primo Water going out of business?
Primo Water Corp. will exit the North American single-use retail bottled water business as part of a strategy to increase profitability and further reduce its carbon footprint , the company announced in a Q3 2021 earnings report.
Is Primo Water owned by Nestle?
Some sources said Primo would have been a good suitor for Nestle Water, but the company wrapped up its own deal recently In January, Cott announced it would acquire Primo for USD 775m, and rebrand itself as Primo.
Is Primo Water still in business?
In March 2020 , the Primo® brand joined our family of brands enhancing our ability to deliver hydration solutions to a new group of thirsty customers, expanding reach and frequency.